Homeowner fall checklist
- Set the thermostat to HEAT and raise the setpoint a few degrees on a mild day to confirm the system starts.
- Install a clean filter; mark the next change date on your calendar.
- Open supply registers and make sure furniture isn't blocking returns.
- Clear leaves, mulch, and toys from around the outdoor heat pump or AC.
- Test carbon monoxide detectors and replace batteries.
- Replace thermostat batteries if applicable.
- Note any unusual smells, short cycling, or weak airflow to tell your tech.
What a pro checks on gas furnaces
- Ignition, flame sense, and safe burner operation.
- Heat exchanger inspection for cracks or rust concerns.
- Inducer, venting, and condensate on high-efficiency units.
- Blower amps, temperature rise, and limit operation.
- Gas pressure and thermostat calibration as needed.
What a pro checks on heat pumps
- Reversing valve and defrost cycle operation.
- Outdoor coil cleanliness and fan condition.
- Refrigerant circuit performance and electrical components.
- Backup heat strips for cold mornings.
- Duct airflow that affects both heating and summer humidity control.
Schedule before the rush
Fall fills up once the first cold front hits. Call (864) 479-6737 or join a maintenance plan to lock in your heating tune-up.
Colder Upstate pockets
Homes in Travelers Rest and higher elevations see colder nights earlier. If you rely on a heat pump there, confirm backup heat works before January. Dual-fuel homes should verify the switchover is configured for local temperatures.